4. Installation

Signal Connections

2.Connect M/E 1 Preview Out to a monitor. This output provides the bank’s “lookahead” preview video. In Chapter 7, refer to the “Understanding Lookahead Preview” section on page 319 for additional information.

3.Connect M/E 1 Clean Out to a monitor or the desired destination. This output provides M/E 1’s clean feed signal. In Chapter 2, refer to the “Clean Feed Output Selection” section on page 52 for details.

„Use the following steps to connect the FSN-1400’s M/E 2 outputs:

1.Connect M/E 2 Program Out to a monitor or the desired destination. This output provides M/E 2’s program output signal.

2.Connect M/E 2 Preview Out to a monitor. This output provides the bank’s “lookahead” preview video. In Chapter 7, refer to the “Understanding Lookahead Preview” section on page 319 for additional information.

3.Connect M/E 2 Clean Out to a monitor or the desired destination. This output provides M/E 2’s clean feed signal. In Chapter 2, refer to the “Clean Feed Output Selection” section on page 52 for details.

Please note the following important points:

On the FSN-150, M/E 2 control must be enabled to fully utilize the M/E 2 outputs. In Chapter 7, refer to the “M/E 2 Control on the FSN-150 section on page 349 for details.

All outputs run at the system’s selected native output resolution.

In Chapter 6, refer to the “Reference Video and Output Setup” section on page 287 for instructions on setting the native resolution.

FSN Series • User’s Guide • Rev 01

 

123

 

Page 123
Image 123
Barco 26-0702000-00 manual Installation, FSN Series • User’s Guide • Rev