Barco 26-0702000-00 manual Control Panel Orientation, Control Panel Descriptions, 4Effects Group

3. Control Panel Orientation

Control Panel Descriptions

KEY

2

~All transition and arm capabilities for KEY 2 are identical to those for KEY 1 — but apply to KEY 2 instead. The DVE prerequisites are also identical — a DVE channel must be assigned to KEY 2 and a two- keyframe DVE effect must be loaded.

Note	The Key Menu can be used at any time to adjust key
	parameters, whether or not the key is on. In Chapter 5, refer
	to the “Keyer Menu” section on page 157 for details.

The following rules apply to all three buttons in the Next Transition Group:

~As you enable or disable buttons in the group, the selected layer appears (or is removed) on the M/E’s Preview output.

~At the end of a transition (either manual or automatic), all buttons that were enabled in the group remain on. This allows you to transition back to the previous look.

~All three buttons in the Next Transition Group work in combination with the M/E’s MIX, WIPE, CUT, FX TRIG, AUTO TRAN button and the T-Bar.

For example:

S If you arm BG and MIX, press AUTO TRAN to automatically mix to the selected source.

S If you arm KEY 1, BG and WIPE, move the T-Barto manually wipe to the selected source plus key.

S If you arm BG and KEY 2, press CUT to cut to the selected source and cut the key on or off.

S If you arm KEY 1 and FX TRIG, press AUTO TRAN to trigger the two-keyframe DVE effect (that is loaded into the DVE channel assigned to KEY 1).

SIf you arm KEY 1, MIX and FX TRIG, press AUTO TRAN to trigger the two-keyframe DVE effect and also mix the KEY 1 layer.

In Chapter 7, use the following section for reference:

~Refer to the “Understanding Lookahead Preview” section on page 319 for additional information about lookahead preview functionality.

~Refer to the “Understanding Switcher Layers” section on page 312 for a discussion of video layers within the switcher.

~In Chapter 8, refer to the “Automatic DVE Triggering” section on page 396 for complete details.

4)Effects Group

The three buttons in the Effects Group indicate which effects are armed for the next transition in the M/E.

MIX

WIPE

FX

TRIG

Figure 3-16. Effects Group

To use the group, press the button(s) for the transition that you want to arm.

86 FSN Series • User’s Guide • Rev 01