Barco 26-0702000-00 manual ìñ=q~ÄäÉ=aÉëÅêáéíáçå, oÉ~ê=fLl=sáÉï=aÉëÅêáéíáçå, Menu Orientation

5. Menu Orientation

System Menu

oÉ~ê=fLl=sáÉï=aÉëÅêáéíáçå

The Rear I/O View for the Aux Setup Menu shows the I/O panels for slots 8, 11, 12 and 13. Slot 8 (the M/E card) contains the six standard Aux outputs. Slots 11 through 13 will show all installed optional UOCs and NACs. This view matches your system configuration exactly — based on the installed cards. Please note:

•The number of each slot is shown along the top.

•Only Aux output connectors will be active in the view — all other connectors will be grayed out, including those on the Multiviewer (if installed in slot 11).

•The type of each installed card is shown along the bottom (e.g., NAC, UOC).

•If a card is not installed, the label “Not Installed” appears in the slot.

•To set up a native Aux output, press the desired connector on the M/E card or on an installed NAC. The yellow border indicates that the connector is selected, and in the Aux Table, the output row is automatically highlighted.

•To set up a universal Aux output on a UOC, press any of the top three connectors to select Output 1, or any of the bottom three connectors to select Output 2. The selected output is highlighted with a yellow border around all three connectors.

Note

UOC connectors that are not outputting video will be grayed out (e.g., for an un-supported video format).

^ìñ=q~ÄäÉ=aÉëÅêáéíáçå

The figure below illustrates a portion of the Aux Table on the Aux Setup Menu:

Slot	Out	Map	Name	Format
8	1	1	VTR 1	Native
8	2	2	VTR 2	Native
8	3	3	Down 1	Native
8	4	4	Down 2	Native
8	5	5	GreenRm	Native
8	6	6	SAT 1	Native
11	1	7	SAT 2	Native

Figure 5-113.Aux Table (sample)

The Aux Table provides information about each Aux output, and the yellow highlight automatically tracks the selected Aux connector in the Rear I/O View. Because more than 16 Aux outputs can be installed (and because the table is only 16 rows in length), the table automatically scrolls as required.

The following columns of information are provided:

•Slot — indicates the selected card slot (8, 11, 12 or 13).

•Out — indicates the selected Aux output:

~1 through 6 on the M/E card.

~1 through 8 for a NAC.

~1 or 2 for a UOC.

FSN Series • User’s Guide • Rev 01 241