Barco 26-0702000-00 manual tçêâáåÖ=ïáíÜ=^ìñ=_ìëÉë, Operations, SPrerequisites

7. Operations

Working with Aux Buses

tçêâáåÖ=ïáíÜ=^ìñ=_ìëÉë

The switcher’s Aux Section enables you to route input sources and selected outputs to various “destinations.”

SPrerequisites

~Ensure that you are familiar with mapping and naming Aux outputs. In Chapter 6, refer to the “Aux Setup” section on page 298 for instructions.

~Ensure that you are familiar with the Aux Section on the control panel. In Chapter 3, refer to the “Aux Section” heading on page 91 for details.

„Use the following steps to assign sources to Aux bus outputs:

1.Ensure that your Aux outputs are mapped and named to your satisfaction.

2.On the Aux Bus Row, select the Aux output that you want to assign.

3.On the Aux Source Row, select one of the following:

~Select a new source or program output (e.g., PGM, M/E).

~Select Black.

~Select an output (e.g., M/E 1, PGM).

~Select a clean feed source by pressing ASSIGN, and choosing the desired source from the Clean Feed Setup Menu. Refer to the “Selecting Clean Feed Outputs” section below for details.

Note

Remember that only one clean feed source can be mapped to the ASSIGN button for all Aux buses. For example, you cannot map “Pre KEY 1” to Aux 1, and “Pre KEY 2” to Aux 2.

4.Repeat the procedure from step 2 to make additional assignments.

346 FSN Series • User’s Guide • Rev 01