Barco 26-0702000-00 råÇÉêëí~åÇáåÖ=mêÉëë=~åÇ=eçäÇ, Operations, FSN Series • User’s Guide • Rev

7. Operations

Understanding Press and Hold

råÇÉêëí~åÇáåÖ=mêÉëë=~åÇ=eçäÇ

MIX

Several buttons on the control panel offer “press and hold” functionality. These functions are essentially menu short-cuts. Please note the following important points:

•A “press and hold” function always takes you directly to the requested new menu, regardless of your current location in the menu system.

•If a pop-up is displayed, the selected “press and hold” function also takes you to the requested new menu. Essentially, this is the same as pressing {No} or {Close} in a pop-up, then navigating to the new menu.

•All “press and hold” functions take effect after the selected control panel button is held down for 1.5 seconds.

Following are descriptions of each “press and hold” function:

•After a mix transition has been armed in the PGM or M/E bank, press and hold the MIX button to display the Transition Menu.

WIPE

•After a wipe transition has been armed in the PGM or M/E bank, press and hold the WIPE button to display the Wipe Menu.

KEY

1

KEY

2

DSK

STORE

RECALL

ASSIGN

•In M/E 1, first enable KEY 1 to “arm” the key, then press and hold KEY 1 to display the Keyer Menu for M/E 1, Key 1. If the key is not armed, the system will not jump to the Keyer Menu.

•In M/E 1, first enable KEY 2 first to “arm” the key, then press and hold KEY 2 to display the Keyer Menu for M/E 1, Key 2. If the key is not armed, the system will not jump to the Keyer Menu.

•First enable DSK to “arm” the key, then press and hold DSK to display the Keyer Menu for the DSK, and display the phantom key bus. If the key is not armed, the system will not jump to the Keyer Menu, nor will the phantom key bus be displayed.

•Press and hold STORE to display the Memory Menu.

•Press and hold RECALL to display the Memory Menu.

•Press and hold the ASSIGN button to display the Clean Feed Setup Menu.

•In the Custom Control section, press and hold FRZ, then press any source button to freeze that source.

•In the Custom Control section, press and hold UNFRZ, then press any source button to un-freeze that source.

318 FSN Series • User’s Guide • Rev 01