Barco 26-0702000-00 manual jìäíáîáÉïÉê=pÉíìé, S Prerequisites, Layout Menu, System Setup

6. System Setup

Multiviewer Setup

jìäíáîáÉïÉê=pÉíìé

	FSN Series system setup: Step 14
14	This procedure enables you to set up all aspects of the Multiviewer.
		S Prerequisites —
		~ Ensure that the Multiviewer is properly connected. In Chapter 4, refer to
		the “Multiviewer Connections” section on page 129.
		~ Ensure that you are familiar with all Multiviewer menus and features.
		Refer to Chapter 9, “Multiviewer Operations” on page 411 for details.
	„ Output Setup — Use the following steps to set up the Multiviewer’s output:
	1.	In the Menu Bar, press {System} to access the System Menu.
	2.	Press {Multiviewer Setup} to display the Multiviewer Setup Menu.
	3.	Press {Output Setup} to display the Multiviewer Output Setup Menu.
	4.	Press {Output Format} to display the Multiviewer Output Format Keypad.
		Select the format supported by the monitor(s) connected to the Multiviewer’s rear
		panel. Press {Apply} to accept, then press {Close} to close the pop-up.
	5.	If you are using the Multiviewer card’s DVI output connector(s), press {DVI Sync}
		and select the desired sync mode.
	6.	Press {Back} to return to the Multiviewer Setup Menu.
	„ Layout — Use the following steps to select the Multiviewer’s layout:
	1.	On the Multiviewer Setup Menu, press {Select Layout} to display the Select
		Layout Menu.
	2.	Press {Single Output Layouts} or {Dual Output Layouts} as required.
	3.	Select one of the pre-configured single or dual screen layouts from the menu.
	4.	Press {Back} to return to the Multiviewer Setup Menu.
	„ Color Setup — Use the following steps to configure the Multiviewer’s color scheme:
	1.	On the Multiviewer Setup Menu, press {Select Colors}.
	2.	Press {BG Color} to change the Multiviewer’s background color. Use the Knobs
		or the Color Picker to select the desired color.
	3.	Press {Clock BG Color} to change the background color of the clock (if enabled
		on your selected layout). Use the Knobs or the Color Picker to select the color.
	4.	Press {Border Color} to change the border color for all PIPs. Use the Knobs or
		the Color Picker to select the color.
	5.	Press {UMD Color 1} to change the UMD 1 color selection. Use the Knobs or the
		Color Picker to select. Note that this unique color can be applied to one or more
		UMDs, using the UMD Color Pop-up. Repeat this step for all four UMD colors.
	6.	Press {Back} to return to the Multiviewer Setup Menu.
	„ Clock Setup — Use the following steps to set up the clock:
	1.	If a clock is configured in your selected layout, press {Clock Setup}.
	2.	Press {Clock Source} and choose the clock’s source, either internal or LTC.
	3.	Press {Clock Display} and choose the display mode, either 12 or 24 hour.

FSN Series • User’s Guide • Rev 01 301