Barco 26-0702000-00 manual qê~åëáíáçå=jÉåì=^ÅÅÉëë, qê~åëáíáçå=o~íÉ=^ÇàìëíãÉåí, Menu Orientation

M/E 1

30

All

Set/Trim

5. Menu Orientation

Transition Menu

qê~åëáíáçå=jÉåì=^ÅÅÉëë

There are two ways to access the Transition Menu:

•In the Menu Bar, press {Page} to display page 1 (if required). Then, press the {Trans} button.

•Press and hold any MIX button on the control panel (e.g., MIX in the M/E 1 bank or the PGM bank).

qê~åëáíáçå=o~íÉ=^ÇàìëíãÉåí

Transition rates can be adjusted from 1 to 999 frames, in 1 frame increments. There are two ways to adjust rates individually:

•Turn the Knob adjacent to the any value button to adjust the auto transition rate (in frames) for that specific location (M/E 1, M/E 1, PGM or FTB).

~The value on the button changes as you adjust, and the associated Transition Display (on the panel) updates.

~Changes in rates take effect immediately.

•To “key in” an auto transition rate, press any value button to display the Keypad for that specific location. Enter a new rate (in frames) and press {Enter}, or trim the current rate using {Trim -}or {Trim +}.

You can also enter or trim all transition rates simultaneously:

•To set all rates to the same value, press {All/Set Trim}. All value buttons light. Next, press any value button to display the keypad.

~To set all rates to the value in the keypad’s register, press {Enter}.

~To set all rates to a new value, enter the new value and press {Enter}.

•To trim all rates simultaneously as offsets to their current values, press {All/Set Trim}. All value buttons light. There are two ways to trim the value:

~Turn any Knob to increment or decrement all rates.

~Press any value button to display the keypad. Enter the desired “trim” value and press {Trim +} or {Trim -}as desired.

FSN Series • User’s Guide • Rev 01 149