Barco 26-0702000-00 manual Menu Orientation, FSN Series • User’s Guide • Rev

5. Menu Orientation

System Menu

•Black bars are visible above and below an image, for example, when a 16:9 image is scaled down to 4:3.

•The top and bottom portions of an image may fall outside of the raster, for example, when a 4:3 image is scaled up to 16:9.

~Press {Fill V} to scale the output up (or down) to the selected vertical resolution. Please note:

•Aspect ratio is maintained. Manual size/position adjustments using the four value buttons are maintained.

•If the top and/or bottom edges of the image are manually masked, those edges are used for the Fill V calculations.

•Black pillars are visible to the left and right of an image, for example, when a 4:3 image is scaled up to 16:9.

•The left and right portions of an image may fall outside of the raster, for example, when a 16:9 image is scaled down to 4:3.

~Press {Fill H/V} to scale the output up (or down) to the selected horizontal and vertical resolutions. Please note:

•Aspect ratio is not maintained. Non-proportional image stretching or compression will occur.

•If any edges of the image are manually masked, those edges are used for the Fill H/V calculations.

~Use the {Reset} function to reset all size and position values to default.

Aspect

Ratio

16:9

Pan

Zoom

Source

When {Size and Position} is selected, one additional function is available in the Tool Bar:

~Press {Aspect Ratio} to display the Aspect Ratio Pop-up. This function affects the output’s H dimension only. Choices are 16:9, 5:4, 4:3, 3:2, 1:1 and Custom.

When {Custom} is selected, the {Adjust Custom Aspect} button appears in the Tool Bar. Press to display the {Custom Aspect} value button. Unlatch to re-display size and position adjustments.

•In the Output Sizing and Scaling section, press {Pan Zoom Source} to display four buttons which enable you to size and position the video within the boundaries of the output’s current sizing. In this mode, the output’s outside boundaries remain constant, but you can pan and zoom the video inside, as desired.

Note	The Pan Zoom Source function does not allow you to reveal
	video that is outside of the output’s active area.

The following functions are provided:

~Press {Source H Size} or use the knob to change horizontal size inside the output’s boundaries. Remember that {Source H Size} and {Source V Size} track together if the {Lock} is enabled.

~Press {Source V Size} or use the knob to change vertical size inside the output’s boundaries.

~Press the {Lock} button to lock or unlock H and V source size tracking. When locked, both parameters track together. When unlocked, H and V can be adjusted independently.

~Press {Source H Pos} or use the knob to change the horizontal position inside the output’s boundaries along the X axis.

250 FSN Series • User’s Guide • Rev 01