Barco 26-0702000-00 manual råáîÉêë~ä=fåéìí=pÉíìé, System Setup, FSN Series • User’s Guide • Rev

6. System Setup

Universal Input Setup

råáîÉêë~ä=fåéìí=pÉíìé

	FSN Series system setup: Step 10
10	In this procedure, you will perform a complete setup on all universal switcher inputs.
	Ensure that your inputs are properly connected to the selected UIC before continuing.

S Prerequisite — Ensure that you are familiar with the following menus: ~ Input Menu — Chapter 5, “Input Menu,” page 202.

~ Connector Colors — Chapter 5, “Connector Colors,” page 204.

~ Input Setup Menu (Universal Inputs) — Chapter 5, “Input Setup Menu for Universal Inputs,” page 214.

„ Universal Input Setup — Use the following steps for basic universal input setup: 1. In the Menu Bar, press {System} to access the System Menu.

2. Press {Input Setup} to display the Input Menu.

Note

Remember that after a factory reset, UIC inputs are not mapped to the panel, but default names are assigned.

3.In the Rear I/O View, press the input connector on the UIC that you want to set up. A yellow highlight is placed around all three input connectors, and in the Input Table, the input is highlighted.

4.Select the individual UIC connector — either the BNC, HD-15or DVI. A green highlight indicates the selection.

5.Press {Map to} to map the selected input to the control panel, or re-map it to another button. When the Map To Pop-upappears, on the Program Bank’s Preset Bus, press the button on which you want the input to appear.

Important

The system allows you to map an input to more than one button. If an input is already mapped to a button and you wish to map it to another location, use the {Un-map}function to remove the button from the unwanted location.

6.Press {Input Name} to name (or re-name) the selected input. When the pop-up Keyboard appears, enter the desired name and press {Enter} on the Keyboard.

7.If required, press {Un-map}to remove the selected input from the panel. Note that the name and all associated setup parameters are retained.

8.Press {Error Reporting} to turn error reporting on or off.

~When on, if an input experiences an error, the connector turns red on the rear I/O view, the input’s Programmable Display turns red, and the “Error” button appears.

~When off, the input’s Programmable Display remains green and the red “Error” button does not appear. The connector remains red.

Note

The {Error Reporting} function works on a connector by connector basis.

FSN Series • User’s Guide • Rev 01 293