Barco 26-0702000-00 manual `çããìåáÅ~íáçåë=pÉíìé, System Setup, FSN Series • User’s Guide • Rev

6. System Setup

Communications Setup

`çããìåáÅ~íáçåë=pÉíìé

	FSN Series system setup: Step 4
4	In this procedure, you will set up communication between the FSN-1400 and the control
	panel.

S Prerequisite — Ensure that you are familiar with the Communications Setup Menu. In Chapter 5, refer to the “Communications Setup Menu” section on page 194.

„ Use the following steps to set up communications:

1. In the Menu Bar, press {System} to access the System Menu.

Important

If communication is not properly set up, numerous buttons will be grayed out on the System Menu. These buttons will activate once communication is properly set.

2.Press {Com Setup} to display the Communications Setup Menu.

3.Review the data in the Ethernet Status Table, and ensure the following:

~FSN-150 Ethernet 1: Connected

~FSN-1400 Ethernet: Connected

If status is “Connected,” communication is properly set up. Please continue with the “Reference Video and Output Setup” procedure on page 287.

4.If status is “Not Connected,” press {Discover FSN-1400}to locate the IP address(es) of all FSN-1400 units within your local network.

~If the pop-up alerts you that no FSN-1400 units have been discovered, check all Ethernet connections, then press {Discover FSN-1400}again to re-try the procedure.

~If FSN-1400 units are discovered, the FSN-1400 Selection Keypad appears. Select the desired FSN-1400, and press {Connect}.

5.(Advanced) If you need to change the IP address of a highlighted port, for example, if your system is connected to a house network, press {Set IP Address} to display the IP Address Keypad. Enter the desired address and press {Enter}.

6.(Advanced) If you need to change the subnet mask of a highlighted port, press {Set Subnet Mask} to display the Subnet Mask Keypad. Enter the desired subnet mask and press {Enter}.

7.(Advanced) If you need to return a highlighted port’s IP address and Subnet Mask to their factory default values, press {Return to Default}.

FSN Series • User’s Guide • Rev 01 285