Barco 26-0702000-00 manual `äÉ~å=cÉÉÇ=pÉíìé, System Setup, FSN Series • User’s Guide • Rev

6. System Setup

Clean Feed Setup

`äÉ~å=cÉÉÇ=pÉíìé

FSN Series system setup: Step 8

8 In this procedure, you can set clean feed outputs, and select a source for the ASSIGN button (in the control panel’s Aux Section).

SPrerequisite — Ensure that you are familiar with the Clean Feed Setup Menu. In Chapter 5, refer to the “Clean Feed Setup Menu” section on page 232.

„Clean Feed Setup — Use the following steps to set clean feed outputs:

1.In the Menu Bar, press {System} to access the System Menu.

2.Press {Clean Feed Setup} to display the Clean Feed Setup Menu.

3.Press {Clean Feed Outputs} to display the Clean Feed Outputs Chart.

4.On the chart, select the desired clean feed point for M/E 1’s clean feed output:

~Press {M/E 1 Clean 1} to select the point prior to Keyer 1 on M/E 1.

~Press {M/E 1 Clean 2} to select the point prior to Keyer 2 on M/E 1.

~Press {M/E 1 Out} to select the point after Keyer 2 on M/E 1.

5.On the chart, select the desired clean feed point for M/E 2’s clean feed output:

~Press {M/E 2 Clean 1} to select the point prior to Keyer 1 on M/E 2.

~Press {M/E 2 Clean 2} to select the point prior to Keyer 2 on M/E 2.

~Press {M/E 2 Out} to select the point after Keyer 2 on M/E 2.

6.Select the desired clean feed point for the PGM bank’s clean feed output:

~Press {PGM Clean} to select the point prior to the DSK.

~Press {PGM Out} to select the point after the DSK.

„ASSIGN Setup — Use the following steps to select the clean feed source that is mapped to the ASSIGN button in the control panel’s Aux Section:

7.Press {Assign Button} to display the Assign Button Chart.

8.Select one of three mutually exclusive clean feed points for the button:

~Press {M/E 1 Clean 1} to select the point prior to Keyer 1 on M/E 1.

~Press {M/E 1 Clean 2} to select the point prior to Keyer 2 on M/E 1.

~Press {M/E 2 Clean 1} to select the point prior to Keyer 1 on M/E 2.

~Press {M/E 2 Clean 2} to select the point prior to Keyer 2 on M/E 2.

~Press {PGM Clean} to select the point prior to the DSK.

Please note:

•The clean feed selection is global for all Aux routes. If you change the mapping for one route, it changes for all routes.

•To quickly display the Assign Button Panel, press and hold the ASSIGN button.

290 FSN Series • User’s Guide • Rev 01