lìíéìí=qÉëí=m~ííÉêåë

6. System Setup

Output Test Patterns

lìíéìí=qÉëí=m~ííÉêåë

 

FSN Series system setup: Step 7 (optional)

7

In this procedure, you can display test patterns on selected system outputs (or all system

outputs), typically for purposes of setting up external devices.

S Prerequisite — Ensure that you are familiar with the Output Test Patterns Menu. In Chapter 5, refer to the “Output Test Patterns Menu” section on page 270.

„ Use the following steps to select and display output test patterns: 1. In the Menu Bar, press {System} to access the System Menu.

2. Press {Output Test Patterns} to display the Output Test Patterns Menu.

3. To display a test pattern on one output:

a. Press the desired output connector in the Rear I/O View on the left side of the menu.

b. Press the desired test pattern in the matrix on the right side of the menu. c. Press {Raster Box} to enable or disable the raster box as desired.

d. When complete, press {Off} to turn the test pattern off.

Note

Remember that you can set a different test pattern on each output.

4.To display a test pattern on all outputs:

a.Press {Select All Outputs}.

b.Press the desired test pattern in the matrix on the right side of the menu.

c.Press {Raster Box} to enable or disable the raster box as desired.

d.When complete, press {All Off}.

Important

Ensure that you press {All Off} after you have finished using any output test pattern.

FSN Series • User’s Guide • Rev 01

 

289

 

Page 289
Image 289
Barco 26-0702000-00 manual lìíéìí=qÉëí=m~ííÉêåë, a.Press Select All Outputs, System Setup, FSN Series • User’s Guide • Rev