Barco 26-0702000-00 manual ~ ~ ~, •M/E 2 Control, •NIC Gamma Adjustment, •Video Reference Output

NK==fåíêçÇìÅíáçå

New Feature Review

•M/E 2 Control

Version 2.0 supports control of M/E 2 from the FSN-150. All M/E 2 outputs on the FSN-1400 are active, a new M/E Setup Menu is provided, and the M/E 2 button in the Memory Section is active. In Chapter 5, refer to the “Other Setup Menu” section for setup details. In Chapter 7, refer to the “M/E 2 Control on the FSN- 150” section for M/E 2 operating instructions.

•NIC Gamma Adjustment

Gamma adjustment has been added to all NIC (Native Input Card) inputs. The adjustment range is 0.5 to 3.0, in .01 increments. In Chapter 5, refer to the “Input Menu” section on page 202 for details.

•Ancillary Data Support for SD Rates

For SD (standard definition) formats, for direct NIC-to-AUXoutput routes, ancillary data present on NIC inputs is now preserved to SDI Aux outputs. However, if the signal travels through an M/E, a UIC or the DVE, ancillary data is stripped. Please note the following important points:

~In Frame Sync mode, if a frame is repeated or dropped, the ancillary data for that frame is also repeated or dropped.

~For HD (high definition) video formats, the same rules apply.

•Video Reference Output

On the Reference and Output Setup Menu, new features are provided:

~Users can adjust the reference video output by toggling the {Reference Out} button to either Black Burst or Tri-level Sync.

Important

This change activates the Ref Out BNC connector on the System Card’s rear panel.

~By pressing {Reference Output Timing}, users can adjust H and V phase relative to video reference input.

Please note:

~In Chapter 2, refer to the “System Card” section on page 44 for information on the Ref Out connector.

~The sync out format (as provided on the Ref Out BNC) changes, depending on the selected native video format. In Appendix A, refer to the “Reference Video Output Specifications” section on page 434 for details on each format.

•Additional Native Video Output Formats

Three new native video output formats have been added to the system:

~

~

~

1920 x 1080p @ 23.98

1920 x 1080p @ 24

1920 x 1080p @ 25

Please note:

~Use the Reference and Output Setup Menu to select the desired native output format. In Chapter 5, refer to the “Reference and Output Setup Menu” section on page 197 for menu details.

~In Appendix A, refer to the “Output Formats” section on page 449 for a complete list of all available output formats.

28 FSN Series • User’s Guide • Rev 01