Barco 26-0702000-00 manual mÜóëáÅ~ä=~åÇ=sáêíì~ä=qJ_~ê=mçëáíáçå, bñ~ãéäÉ=NW==kçêã~ä=qJ_~ê=ãçîÉãÉåí

7. Operations

Understanding the T-Bar and Transition LEDs

•Automatic transitions can be paused:

~Press AUTO TRAN to start the transition.

~Press AUTO TRAN again, during the interval, to pause the transition. Note that the Transition LEDS are paused in between the limits.

~Press AUTO TRAN to resume the transition.

~You can pause and resume repeatedly.

•Transitions can be started automatically, paused, and finished manually.

~Press AUTO TRAN to start the transition.

~Press AUTO TRAN again, during the interval, to pause the transition.

~Move the T-Barto continue the transition manually.

•Transitions can be started automatically, and over-ridden manually.

~Press AUTO TRAN to start the transition.

~During the interval, move the T-Barin the same direction as the Transition LEDs are moving, to continue the transition manually.

•Transitions can be started manually, and finished automatically.

~Move the T-Barto perform a manual transition.

~Stop the T-Barat any point before the end-limit.

~Press AUTO TRAN to complete the transition automatically.

Note

Using AUTO TRAN, you cannot return to the BG (or PGM) bus, as you can with manual transitions, unless you manually “match” physical and virtual positions, and return manually to BG (or PGM). Refer to the “Physical and Virtual T-Bar Position” section below for additional details.

mÜóëáÅ~ä=~åÇ=sáêíì~ä=qJ_~ê=mçëáíáçå

The Transition LEDs next to the T-Barreflect the state of the transition, not the position of the physical T-Bar. Often they will be the same — but sometimes, the physical T-Barposition and the “virtual” T-Barposition may not match.

To learn about physical and virtual T-Barpositions, please practice the following examples.

bñ~ãéäÉ=NW==kçêã~ä=qJ_~ê=ãçîÉãÉåí

„Use the following steps to demonstrate physical vs. virtual T-Barposition, in normal “auto-trans” mode:

1.In the M/E or the PGM bank, start with the T-Barat the bottom limit.

2.Press AUTO TRAN to begin the auto transition.

3.Press AUTO TRAN again (during the interval) to pause the transition at 50%. Physical and virtual T-Barpositions do not match. In this situation, the T-Barhas no effect on the video unless you move it up to 50%, and match the physical position with the virtual position.

4.Move the T-Barto 50%. The T-Baris now "live" again, and physical and virtual positions are matched. You can move it up or down as required.

5.Move the T-Barto 75%. The Transition LEDs match the position of the T-Bar.

326 FSN Series • User’s Guide • Rev 01