Barco 26-0702000-00 manual 1Ejectors, 2Card Power LED, 3Loaded LED, 4Program Out, 5Preview Out

Models: 26-0702000-00

1 474
Download 474 pages 62.9 Kb
Page 50
Image 50
1)Ejectors

2. FSN-1400 Orientation

Card Descriptions

Following are descriptions of all M/E card components:

1)Ejectors

Use the card’s top and bottom Ejectors to remove (and re-insert) the card.

2)Card Power LED

The Card Power LED indicates power status for the card. Refer to the “Card LEDs” section on page 64 for details.

3)Loaded LED

The Loaded LED indicates the status of all FPGAs on the card. Refer to the “Card LEDs” section on page 64 for details.

4)Program Out

Two BNC connectors are provided for the system’s main Program Output. Each output is identical.

5)Preview Out

One BNC is provided for the system’s main Preview Output. This output provides the Program bank’s “lookahead” preview output. In Chapter 7, refer to the “Understanding Lookahead Preview” section on page 319 for information.

6)Clean Feed Out

One BNC is provided for the system’s main Clean Feed Output. Refer to the “Clean Feed Output Selection” section on page 52 for details.

7)M/E 1 Program Out

One BNC is provided for the system’s M/E 1 Program Output.

8)M/E 1 Preview Out

One BNC is provided for the system’s M/E 1 Preview Output. This output provides M/E 1’s “lookahead” preview output. In Chapter 7, refer to the “Understanding Lookahead Preview” section on page 319 for information.

9)M/E 1 Clean Feed Out

One BNC is provided for the system’s M/E 1 Clean Feed Output. Refer to the “Clean Feed Output Selection” section on page 52 for details.

10)M/E 2 Program Out

One BNC is provided for the system’s M/E 2 Program Output.

11)M/E 2 Preview Out

One BNC is provided for the system’s M/E 2 Preview Output. This output provides M/E 2’s “lookahead” preview output. In Chapter 7, refer to the “Understanding Lookahead Preview” section on page 319 for information about lookahead preview.

Note

On the FSN-150, M/E 2 control must be enabled to fully utilize these outputs. In Chapter 7, refer to the “M/E 2 Control on the FSN-150 section on page 349 for details.

12)M/E 2 Clean Feed Out

One BNC is provided for the system’s M/E 2 Clean Feed Output. Refer to the “Clean Feed Output Selection” section on page 52 for details.

50

 

FSN Series • User’s Guide • Rev 01

 

Page 50
Image 50
Barco 26-0702000-00 manual 1Ejectors, 2Card Power LED, 3Loaded LED, 4Program Out, 5Preview Out, 6Clean Feed Out