Barco 26-0702000-00 manual fåéìí=`~éíìêÉ=~åÇ=mêçÅÉëë=m~åÉä, fåéìí=`~éíìêÉ=~åÇ=qáãáåÖ=pÉÅíáçå

Capture

And

Process

5. Menu Orientation

System Menu

fåéìí=`~éíìêÉ=~åÇ=mêçÅÉëë=m~åÉä

On the Input Setup Menu for universal inputs, press {Capture and Process} to display the Input Capture and Process Panel.

The panel is divided into two sections:

•Input Capture and Timing Section

•Input Processing Section

fåéìí=`~éíìêÉ=~åÇ=qáãáåÖ=pÉÅíáçå

The figure below illustrates the Input Capture and Timing Section:

Capture and Timing

Auto

Acquire

Off

Adjust

H

Timing

Input

Format

Adjust

V

Timing

EDID

Format

Color

Space

SMPTE

1:1

Sample

On

Sample

Phase

Auto

Acquire

Off

Figure 5-92.Input Capture and Timing Section, Universal Inputs

The following adjustments are provided:

•Press {Auto Acquire} to toggle the Auto Acquire mode On or Off. This function is per connector on the UIC, and not per input.

~When Off, you can manually set the resolution of the incoming source using the {Input Format} button.

~When On, the system attempts to detect the input resolution. As the system auto-acquires, it compares the incoming signal to the formats stored in the Input Format Table. When an exact match is found, the format is applied and the Format field in the table is updated.

Note	If an exact match cannot be found, you may need to use
	{Input Format} button to set the format manually.
Please note the following important points regarding Auto Acquire:

~Once the system acquires a new input format, it automatically scales the input up (or down) to the current native resolution.

~The input’s aspect ratio is fully maintained in this process, and no masking will be applied. For example:

S If a 1024 x 768 input is scaled up to 1920 x 1080 (HD/1080i), the system fills vertically, leaving black pillars on either side.

S If a 1920 x 1080 input is scaled down to 1280 x 720 (HD/720p), the system fills horizontally, leaving black bars on the top and bottom.

~After the input has been acquired, you can manually change the method by which the system fills the screen, and you can also mask any edge and re-scale the input. Refer to the “Input Sizing and Scaling Panel” section on page 219 for details.

FSN Series • User’s Guide • Rev 01 215