Barco 26-0702000-00 manual 2Aux Source Row, 3Assignable Source, Control Panel Orientation

3. Control Panel Orientation

Control Panel Descriptions

2)Aux Source Row

The Aux Source Row provides all the sources available on the switcher’s main buses, plus dedicated buttons for the switcher’s PGM and M/E outputs. When you select a source, it is routed to the output selected on the Aux Output Row.

The following rules apply:

ASSIGN

~The sources on the Aux Source Row are identical to those on the switcher’s main buses. If a button map is changed on the main rows, it also changes on the Aux Source Row.

~On the FSN-150, sources 1 through 10 are unshifted. Sources 11 through 20 are accessed via SHIFT.

~Source assignments on the row can be changed at any time.

~One clean feed source can be mapped to the ASSIGN button. See below for details.

~Only one button on the Aux Source Row can be lit at a time. This button shows the source that is assigned to the selected Aux output. In the figure below, source 2 is assigned to Aux output 2:

AUX

1	2	3	4	5	6	Aux Output Row
9	10	11	12	13	14
BLACK						Aux Source Row

Figure 3-19.Sample source-to-output assignment, FSN-150

3)Assignable Source

In addition to dedicated sources on the Aux Source Row, one additional source can be mapped to the ASSIGN button, as selected from the following five clean feed sources:

~M/E 1 out clean — pre KEY 1

~M/E 1 out clean — pre KEY 2

~M/E 2 out clean — pre KEY 1

~M/E 2 out clean — pre KEY 2

~Program out clean — pre DSK

To assign a clean feed source to the ASSIGN button, press and hold ASSIGN, then use the Clean Feed Setup Menu. In Chapter 5, see the “Clean Feed Setup Menu” section on page 232 for details.

Important

Only one clean feed source can be mapped to the ASSIGN button for all Aux buses. For example, you cannot map “Pre KEY 1” to Aux 1, and “Pre KEY 2” to Aux 2.

In Chapter 7, refer to the “Working with Aux Buses” section for more information.

92 FSN Series • User’s Guide • Rev 01