Barco 26-0702000-00 manual `~äáÄê~íÉ=qçìÅÜ=pÅêÉÉå, FINE ADJUST and ENTER buttons on the Keypad

Models: 26-0702000-00

1 474
Download 474 pages 62.9 Kb
Page 259
Image 259
`~äáÄê~íÉ=qçìÅÜ=pÅêÉÉå

Joystick

On

Re-

center

T-Bar

M/E

On

Set Top

Limit

Set

Bottom

Limit

5. Menu Orientation

System Menu

Press {Joystick} to toggle the Joystick on and off. When you toggle the Joystick off, a pop-up asks you to confirm the procedure. When off, the Joystick no longer functions, and the {Re-center}button is grayed out.

Note

It is recommended that you leave the Joystick on.

 

 

Ensure that the Joystick is fully at rest, then press {Re-center}to re-center the X, Y and Z axes. Use this function only if the Joystick does not display 0% on all axes when fully at rest.

Press {T-Bar M/E} to toggle the M/E’s T-Baron and off. When you toggle it off, a pop-up asks you to confirm the procedure. When off, the T-Barno longer functions on the control panel, and the {Set Top Limit} and {Set Bottom Limit} buttons are grayed out.

Note

It is recommended that you leave the T-Baron.

Note

 

 

The {T-Bar PGM} button performs the identical function for

 

the PGM bank’s T-Bar.

 

 

A {Set Top Limit} button is provided for each T-Baron the switcher. Move the selected T-Barto its top limit, then press {Set Top Limit} to calibrate the T-Bar’s top position. In the pop-up, press {Calibrate}.

A {Set Bottom Limit} button is provided for each T-Baron the switcher. Move the selected T-Barto its bottom limit, then press {Set Bottom Limit} to calibrate the T-Bar’s bottom position. In the pop-up, press {Calibrate}.

Calibrate

Touch

Screen

`~äáÄê~íÉ=qçìÅÜ=pÅêÉÉå

From the Diagnostics Menu, press {Calibrate Touch Screen} to run the Touch Screen’s interactive calibration routine. A special calibration screen appears, on which you will be asked to touch certain areas, and then accept the new calibration. After you accept the calibration, the system will return to the FSN Series menus.

Tip

For a more accurate calibration, use a pencil eraser instead

 

of your finger tip.

Important

 

 

As an alternate method, if required, you can start the Touch

 

Screen calibration procedure by simultaneously pressing the

 

FINE ADJUST and ENTER buttons on the Keypad.

 

 

FSN Series • User’s Guide • Rev 01

 

259

 

Page 259
Image 259
Barco 26-0702000-00 manual `~äáÄê~íÉ=qçìÅÜ=pÅêÉÉå, FINE ADJUST and ENTER buttons on the Keypad, Menu Orientation