Barco 26-0702000-00 manual 1System Power LED, 2Video Reference LED, 3Ejectors, 4Card Power LED

Models: 26-0702000-00

1 474
Download 474 pages 62.9 Kb
Page 45
Image 45
1)System Power LED

2. FSN-1400 Orientation

Card Descriptions

Following are descriptions of all components on the front edge of the System card:

1)System Power LED

The System Power LED indicates power status for the chassis and the cards.

~Green = all system power is OK.

~Red = one or more of the following conditions are present:

DC output from one (of the two) chassis power supplies is bad or has failed.

Power is bad (or has failed) on one or more of the installed circuit cards.

~Off = one or more of the following conditions are present:

The chassis is turned off.

DC output from all power supplies is bad or has failed.

Power has failed on the System Card.

Note that this LED is carried through to the front door via light pipe.

2)Video Reference LED

The Video Reference LED indicates the status of the system’s analog video reference input, via the Vid Ref connector on the System Card’s rear panel.

~Green = the system is configured for External Reference, a video reference signal is present and the FSN-1400 is locked to the signal.

~Red = the system is configured for External Reference, the signal is missing or the FSN-1400 is not locked to the signal.

~Off = the system is configured for Free Run.

Note

If the Power LED is off, the Video Reference LED will also be off.

Note that this LED is carried through to the front door via light pipe.

3)Ejectors

Use the card’s top and bottom Ejectors to remove (and re-insert) the card.

4)Card Power LED

The Card Power LED indicates power status for the card. Refer to the “Card LEDs” section on page 64 for details.

5)Loaded LED

The Loaded LED indicates the status of all FPGAs on the card. Refer to the “Card LEDs” section on page 64 for details.

6)Diagnostic Port

One RS-232 port is provided for diagnostics. This port is not available to the user.

7)CPU Reset Switch

Using a small tool such as a paper clip, press the CPU Reset Switch to perform a soft system reset. This function reboots the system, but preserves all setups and memory registers, and maintains all crosspoint selections on the control panel.

Please note:

~This is the same as pressing {Soft Reset System} on the Reset Menu. In Chapter 5, refer to the “Reset Menu” section on page 274 for details.

FSN Series • User’s Guide • Rev 01

 

45

 

Page 45
Image 45
Barco 26-0702000-00 1System Power LED, 2Video Reference LED, 3Ejectors, 4Card Power LED, 5Loaded LED, 6Diagnostic Port