Barco 26-0702000-00 manual mdj=_~åâ=qêáÖÖÉêë, ~Press AUTO TRAN, DVE Operations

8. DVE Operations

Introduction to the DVE

•Automatic trigger — simplified procedure:

~Program the dual keyframe effect.

~Enable the associated keyer on the M/E.

~Select the desired transition (e.g., mix key, wipe key, etc.). If you don’t enable MIX or WIPE, only the effect will run.

~Enable the FX TRIG button.

~Press AUTO TRAN.

Note	Please note the following important points:
	• This method runs the DVE effect plus any associated
	transition (e.g., mix key, wipe key).
	• The FX TRIG button must be enabled.
	• The effect can be paused by pressing AUTO TRAN
	during the run interval.

Refer to the “Automatic DVE Triggering” section on page 396 for expanded instructions on triggering DVE effects on the M/E.

mdj=_~åâ=qêáÖÖÉêë

Because there is no FX TRIG button in the PGM bank’s Transition Section, there is only one way to trigger a dual keyframe DVE effect on this bank:

•Menu trigger — simplified procedure:

~Program the dual keyframe effect.

~Enable the DSK.

~Run the effect using the forward (X) and backward (W) buttons on the DVE menu.

Note

Please note the following important points:

•This method only runs the DVE effect.

•The effect cannot be paused during the run interval.

358 FSN Series • User’s Guide • Rev 01