Barco 26-0702000-00 manual Menu Orientation, FSN Series • User’s Guide • Rev

1:1

Sample

On

Sample

Phase

Adjust

H

Timing

Adjust

V

Timing

5. Menu Orientation

System Menu

~Select RGB to process the input signal in RGB color space (4:4:4), in which the individual red, green and blue signals are sampled at the same rate. The RGB mode is typically used for computer and graphic sources.

Note	This function is available for DVI and analog inputs only, with
	the exception of NTSC and PAL. The button does not appear
	when an SDI, NTSC or PAL input is selected on the UIC.

•Press {1:1 Sample} to toggle the 1:1 sampling mode on or off.

~Select On to process the input with pixel-for-pixel sampling to provide better image quality.

~Select Off to process the input with multiple samples for every pixel. This mode generally results in a “softer” image.

Note	This function is available for analog inputs only, with the
	exception of NTSC and PAL. The button does not appear
	when SDI, DVI, NTSC or PAL inputs are selected on the UIC.

•Press {Sample Phase} to display the Sample Phase value button. Use the button (or knob) to adjust the input’s A/D converter, allowing you to select where pixels are sampled (ideally, on the pixel’s peak).

Range: -16 to 15

Default: 0

For optimum visual results when adjusting high-resolution sources, output a burst test pattern from the source, and adjust for minimum noise.

Note	This function is available for analog inputs only, with the
	exception of NTSC and PAL. The button does not appear
	when SDI, DVI, NTSC or PAL inputs are selected on the UIC.

•Press {Adjust H Timing} to adjust the image’s horizontal timing. Three value buttons appear:

~Use the {H Pos} button (or knob) to set the start of the active area’s horizontal offset from H sync.

~Use the {H Active} button (or knob) to set the width of the active area.

~Use the {H Total} button (or knob) to set the total pixel count per line.

Note	This function is available for analog inputs only, with the
	exception of NTSC and PAL. The button does not appear
	when SDI, DVI, NTSC or PAL inputs are selected on the UIC.

•Press {Adjust V Timing} to adjust the image’s vertical timing. Two value buttons appear:

~Use the {V Pos} button (or knob) to set the start of the active area’s vertical offset from V sync.

~Use the {V Active} button (or knob) to set the number of vertical lines in the image.

FSN Series • User’s Guide • Rev 01 217