pÉäÉÅíáåÖ=`äÉ~å=cÉÉÇ=lìíéìíë

7. Operations

Selecting Clean Feed Outputs

pÉäÉÅíáåÖ=`äÉ~å=cÉÉÇ=lìíéìíë

The Clean Feed Setup Menu enables you to set clean feed outputs, and the source for the ASSIGN button (in the control panel’s Aux Section).

SPrerequisites

~Ensure that you are familiar with the Aux Section. In Chapter 3, refer to the “Aux Section” heading on page 91 for details.

~Ensure that you are familiar with the Clean Feed Setup Menu. In Chapter 5, refer to the “Clean Feed Setup Menu” section on page 232.

„Use the following steps to select clean feed outputs and the ASSIGN button source:

1.Navigate to the System Menu:

~In the Menu Bar, press {Page} to display page 2 (if required). Then, press the {System} button.

2.Press {Clean Feed Setup} to display the Clean Feed Setup Menu.

3.To set clean feed outputs:

~Press the blue {Clean Feed Outputs} button. The Palette changes to the Clean Feed Outputs flowchart.

~Select the desired clean feed point for each output.

4.To set the ASSIGN button source:

~Press {Assign Button}. The Palette changes to the Assign Button flowchart.

~Select the desired clean feed point for the ASSIGN button.

Note

Remember that only one clean feed source can be mapped to the ASSIGN button for all Aux buses. For example, you cannot map “Pre KEY 1” to Aux 1, and “Pre KEY 2” to Aux 2.

FSN Series • User’s Guide • Rev 01

 

347

 

Page 347
Image 347
Barco 26-0702000-00 manual pÉäÉÅíáåÖ=`äÉ~å=cÉÉÇ=lìíéìíë, Operations, SPrerequisites, FSN Series • User’s Guide • Rev