Manual background

4. Installation

FSN-1400 Rack-Mount Procedure

3.To facilitate easy rack mounting, each rack ear on the front of the FSN-1400 is equipped with a special “keyhole” slot on the lower hole, as shown below.

Figure 4-7.Rack Ear Keyhole

To take advantage of this feature, ensure that there is at least 1/2” of clearance above the chassis’ intended 6RU location.

.5" Additional

Clearance

6RU

Figure 4-8.Equipment Rack Layout

4.For the FSN-1400’s two keyhole slots, measure and install two rack screws in your equipment rack’s front rails. Allow each screw to protrude approximately 3/4” from the surface of the rails.

5.Lift the chassis, and while supporting it, slide the side rails through the slots in the rear mounting brackets.

6.While continuing to support the chassis, slide the screws (in the front rails) through the two keyholes, and let the chassis settle up into the keyhole slots.

7.Tighten the two lower screws, then install and tighten the two uppers screws in the rack rail.

FSN Series • User’s Guide • Rev 01

 

111

 

Page 111
Image 111
Barco 26-0702000-00 manual Installation, FSN Series • User’s Guide • Rev