Manual background

AUTO

TRAN

FINE

ADJUST

CLEAR

TRIM -

TRIM +

1

+ / -

3. Control Panel Orientation

Control Panel Descriptions

parallel with the Touch Screen’s keypad — either one can be used for entry, depending on your preference.

Following are descriptions of each Keypad button:

~The AUTO TRAN button is not available in version 3.0.

~Press BACKSPACE () during a numeric entry process to clear the register by one digit with each press.

~Press FINE ADJUST to change the sensitivity of the knobs and the Joystick.

When off, adjustment is coarse.

When on, adjustment is fine.

~Press CLEAR during a numeric entry process to clear the entire register. A dash () appears in the register, but the selected mode (store or recall) and all selected modules remain lit.

Press and hold CLEAR to cancel the current store or recall function completely. The STORE or RECALL button automatically turns off.

~Enter an offset value using the numeric buttons, then press TRIM - to subtract from the parameter’s current value. For example, if a parameter’s value is 100, press 10, TRIM -, to calculate 90. Pressing ENTER is not required, and the “trim” value remains in the register, enabling you to trim repeatedly by the same offset.

In Chapter 5, see the “Using the Keypad” section for details.

Note

The TRIM - function is only applicable when a Touch Screen

 

Keypad is active. It does not apply to memory registers.

 

 

~Enter an offset using the numeric buttons, then press TRIM + to add to the parameter’s value. For example, starting with 100, press 10, TRIM +, to calculate 110. Pressing ENTER is not required. The “trim” remains in the register, enabling you to trim repeatedly by the same offset.

In Chapter 5, see the “Using the Keypad” section for details.

Note

The TRIM + function is only applicable when a Touch Screen

 

Keypad is active. It does not apply to memory registers.

 

 

~Press the numeric buttons 0 through 9 to enter numbers for memory registers and other functions in the normal manner. Numbers shift left in the register as you enter them.

~Press +/- to invert the numeric entry in the register. For example, to change the entry from + 350 to - 350, press +/-.

Note

The +/- button is only applicable when certain Touch Screen

 

Keypad functions that accept negative values are active.

 

The +/- button does not apply to memory registers.

 

 

FSN Series • User’s Guide • Rev 01

 

97

 

Page 97
Image 97
Barco 26-0702000-00 manual Control Panel Orientation, FSN Series • User’s Guide • Rev