Barco 26-0702000-00 manual k~ãáåÖ=oÉÖáëíÉêë, •View Mode •Store Mode, •Access the Pop-upKeyboard

5. Menu Orientation

Memory Menu

Memory Register

123

Descrip-

tion

•Memory Menu, Value Button Selection — In the Store, Recall and View modes, on both the Memory Menu and the Enables Menu, you can select a register by pressing the {Memory Register} value button. When the Keypad appears, enter the desired register and press {Enter}. The highlight jumps to the selected register.

Please note the following important points regarding register selection and tracking:

•As you enter register numbers using the physical Keypad, the highlight in the table tracks the register accordingly — for each digit entered. For example, if the target register is 123, the highlight jumps to register 1 when the first digit is entered, register 12 when the second digit is entered, and register 123 when you complete the entry.

•As you enter register numbers using the physical Keypad in both Store and Recall modes, the module buttons track in the Memory Section — for each digit entered. For example, if the target register is 123:

~When the first digit (1) is entered, the modules already stored in that register light (if any).

~When the second digit (2) is entered, the modules already stored in register 12 light (if any). These modules may be different than those in register 1.

~When the third digit (3) is entered, the modules already stored in register 123 light (if any). Again, these modules may be different than those stored in register 12.

k~ãáåÖ=oÉÖáëíÉêë

The “name register” feature is available in the following memory modes only:

•View Mode

•Store Mode

By default, new registers are named Register_[n], where [n] is the number of the selected register. As desired, you can enter a custom description of a register.

To use the feature:

•Access the Pop-up Keyboard:

~From the Memory Menu, highlight the desired register in the table, and then press {Description}.

~From the Enables Menu, press {Description}.

•Enter a brief description, then press {Enter} to close the Keyboard.

Note

In View Mode, the new (or edited) description appears immediately in the register table. In Store Mode, the new (or edited) description will not appear in the table until the ENTER button is pressed on the Keypad.

Refer to the “Using the Pop-up Keyboard” section on page 147 for more information about the Keyboard.

184 FSN Series • User’s Guide • Rev 01