Barco 26-0702000-00 manual ìñ=jÉåì, Menu Orientation, FSN Series • User’s Guide • Rev

5. Menu Orientation

Aux Menu

^ìñ=jÉåì

The figure below illustrates a sample Aux Menu.

Figure 5-68.Aux Menu (sample)

The Aux Menu provides status-at-a-glance for all installed Aux outputs, plus the ability to select a specific Aux bus on which to switch sources. To access the menu, press {Page} in the Menu Bar to display page 2 (if required). Then, press the {Aux} button.

The Aux Table provides three columns:

•The Aux column lists each installed (or mapped) Aux output, in ascending order. If an Aux bus is mapped (or re-mapped) on the Aux Setup Menu, that change is reflected in this column.

•The Name column lists each Aux output’s default or custom name. Default names are “AUX ##.” Custom names can be up to eight characters in length.

•The Source column displays the names of the sources routed to each Aux output. The column displays system-generated names (such as Program) as well as user-defined names as configured on the Input Setup Menu.

Note

All setup, mapping and naming of Aux outputs is performed on the Aux Setup Menu. Refer to the “Aux Setup Menu” section on page 240 for details.

186 FSN Series • User’s Guide • Rev 01