Barco 26-0702000-00 manual táéÉ=jÉåì=^ÅÅÉëë, táéÉ=m~ííÉêåë, táéÉ=cìåÅíáçåë=~åÇ=jçÇáÑáÉêë, • • • •

5. Menu Orientation

Wipe Menu

táéÉ=jÉåì=^ÅÅÉëë

There are two ways to access the Wipe Menu:

•In the Menu Bar, press {Page} to display page 1 (if required). Then, press the {Wipes} button. The parameters for the last selected or modified wipe are displayed.

•Press and hold any WIPE button on the control panel (e.g., WIPE in the M/E 1 bank or the PGM bank). The parameters for that specific location are displayed, and named in the menu’s Title Bar (e.g., Wipe Menu: M/E 1).

táéÉ=m~ííÉêåë

The Palette provides a matrix of Wipe pattern buttons, which are all mutually exclusive. When a wipe button is pressed, the button is highlighted with a yellow border, and the selected pattern is now available for use and modification on the selected bank.

When you perform a wipe, video on the BG bus is replaced by video on the PST bus, using the selected pattern to “reveal” PST bus video. Each button represents the split between BG and PST video, with the T-Barat approximately 50%, as shown below:

Figure 5-28.Wipe button representation

táéÉ=cìåÅíáçåë=~åÇ=jçÇáÑáÉêë

In the Wipe Menu, the buttons on the Tool Bar and in the Palette allow you to modify the wipe pattern in a variety of creative ways.

Important

All wipe modifiers are additive. This means that you can enable as many modifiers as desired for a selected pattern, without cancelling out any previous ones.

The following modifiers are discussed:

•

•

•

•

Bank

Direction

Edge

Edge Color

152 FSN Series • User’s Guide • Rev 01