Barco 26-0702000-00 4MVR Output, 5MVR Output, 6LTC Input, FSN-1400Orientation, 1x DVI-I 1x BNC

2. FSN-1400 Orientation

Card Descriptions

4)MVR Output 1

In order to provide multiviewer connections to both SDI and DVI compatible monitors, two connectors are provided for MVR Output 1:

~

~

1x DVI-I

1x BNC

The same output signal appears on both the DVI-Iand BNC connectors. MVR Output 1 can be used in both single and dual multiviewer monitor configurations, as selected on the Multiviewer Setup Menu:

~In a single monitor layouts, the selected layout appears identically on MVR Output 1 and MVR Output 2.

~In a dual monitor layouts, one half of the selected layout appears on MVR Output 1, and the other half appears on MVR Output 2.

Please note:

~The output resolution for both MVR outputs is set on the Multiviewer Output Setup Menu, using the Output Format Keypad.

~Both the BNC and DVI-Iconnectors can be active at the same time, provided that the selected format is compatible. The valid combinations are fully listed in the Output Format Keypad.

~Refer to Chapter 9, “Multiviewer Operations” on page 411 for full multiviewer setup details.

5)MVR Output 2

Output connections for MVR Output 2 are identical to MVR Output 1. See above for details.

6)LTC Input

One Phoenix connector is provided for the Multiviewer’s LTC (Longitudinal Time Code) Input.

Figure 2-14.LTC Input connector

Two types of time code connections are possible:

~

~

For a differential connection, use the +, – and GND terminals. For a single-ended connection, use the + and GND terminals.

Please note:

•Test patterns can be assigned to any MVR output, and a raster box can be turned on or off. In Chapter 5, see the “Output Test Patterns Menu” section for details.

FSN Series • User’s Guide • Rev 01 63