Barco 26-0702000-00 k~íáîÉ=fåéìí=pÉíìé, Press Input Setup to display the Input Menu, System Setup

6. System Setup

Native Input Setup

k~íáîÉ=fåéìí=pÉíìé

	FSN Series system setup: Step 9
9	In this procedure, you will perform a complete setup on all native switcher inputs. Ensure
	that your inputs are properly connected to the selected NIC before continuing.

S Prerequisite — Ensure that you are familiar with the following menus: ~ Input Menu — Chapter 5, “Input Menu,” page 202.

~ Connector Colors — Chapter 5, “Connector Colors,” page 204.

~ Input Setup Menu (Native Inputs) — Chapter 5, “Input Setup Menu for Native Inputs,” page 209.

„ Native Input Setup — Use the following steps for basic native input setup: 1. In the Menu Bar, press {System} to access the System Menu.

2. Press {Input Setup} to display the Input Menu.

Note

After a factory reset, all inputs on NIC #1 are mapped to the control panel, in a 1-1 layout to unshifted buttons 1 through 8. Default names are assigned. No other inputs are mapped.

3.In the Rear I/O View, press the connector on the NIC that you want to set up. In the Input Table, the input is highlighted.

4.Press {Map to} to map the selected input to the control panel, or re-map it to another button. When the Map To Pop-upappears, on the Program Bank’s Preset Bus, press the button on which you want the input to appear.

Important

The system allows you to map an input to more than one button. If an input is already mapped to a button and you wish to map it to another location, use the {Un-map}function to remove the button from the unwanted location.

5.Press {Input Name} to name (or re-name) the selected input. When the pop-up Keyboard appears, enter the desired name and press {Enter} on the Keyboard.

6.If required, press {Un-map}to remove the selected input from the panel. Note that the name and all associated setup parameters are retained.

7.Press {Error Reporting} to turn error reporting on or off.

~When on, if an input experiences an error, the input’s BNC turns red on the rear I/O view, the input’s Programmable Display turns red, and the “Error” button appears.

~When off, the input’s Programmable Display remains green and the red “Error” button does not appear. The connector remains red.

Note

The {Error Reporting} function works on a connector by connector basis. You can have reporting on for one connector, and off for another.

FSN Series • User’s Guide • Rev 01 291