tçêâáåÖ=ïáíÜ=`ìíë

7. Operations

Working with Cuts

tçêâáåÖ=ïáíÜ=`ìíë

CUT

A Cut is an instant switch (or “take”) between two sources. There are two different ways to perform a cut:

„Use the following steps to perform a cut, without first previewing the next source:

1.On any PGM or BG bus, simply press the button for the desired source. Use the SHIFT button if required to select a shifted source. Remember that on the PGM bank, the M/E (re-entry) button can be selected in the same way.

„Use the following steps to perform a cut using lookahead preview:

1.In the Next Transition Group, press BG.

2.On any PST bus, press the button for the desired “next” source. Use the SHIFT button if required to select a shifted source. Remember that on the PGM bank, the M/E (re-entry) button can be preset in the same way.

3.Press CUT. The source on PST instantly cuts to PGM (or BG) and the buses flip- flop.

4.Press CUT again to return to the previous source, or select a new source on PST and repeat the procedure.

Note

You can also press ALL CUT (in the Custom Control Section) to perform a cut on all buses simultaneously.

FSN Series • User’s Guide • Rev 01

 

329

 

Page 329
Image 329
Barco 26-0702000-00 tçêâáåÖ=ïáíÜ=`ìíë, In the Next Transition Group, press BG, Operations, FSN Series • User’s Guide • Rev