Barco 26-0702000-00 rëÉê=mêÉÑÉêÉåÅÉë=pÉíìé, ~ Set Black on Invalid Video on or off, System Setup

6. System Setup

User Preferences Setup

rëÉê=mêÉÑÉêÉåÅÉë=pÉíìé

	FSN Series system setup: Step 16
16	This procedure enables you to set a variety of important user preferences and options.
		S Prerequisite — Ensure that you are familiar with the User Preferences
		Menu. In Chapter 5, refer to the “User Preferences Menu” section on
		page 254.
	„ Use the following steps to set user preferences:
	1.	In the Menu Bar, press {System} to access the System Menu.
	2.	Press {User Prefs} to display the User Preferences Menu.
	3.	Use the top knob to select the “preference” that you wish to change, or simply
		touch the desired line in the table.
		~ Set Bus Display Brightness, from 1 (dim) to 10 (bright).
		~ Set Control Panel Backlight, from 1 (dim) to 10 (bright).
		~ Set Touch Screen Brightness, from 1 (dim) to 10 (bright).
		~ Set Transition Display Brightness, from 1 (dim) to 10 (bright).
		~ Set Transition Display Contrast, from 1 (low contrast) to 10 (high
		contrast).
		~ Set Black on Invalid Video on or off.
	4.	Press {Set Clock} to display the Set Clock Keypad:
		~ Ensure that you use the HH:MM:SS format to set the time.
		~ Use the {:} button as a separator between digits.
		~ Press {AM/PM} to switch between AM and PM as required.
		~ Press {12 HR / 24 HR} to switch modes as required.
	5.	Press {Set Date} to display the Set Date Keypad.
		~ Ensure that you use the MM/DD/YYYY format to set the date.
		~ Use the {/} button as a separator between digits.
	6.	If required, press {Reset to Default} to return a highlighted preference to its
		default value.

304 FSN Series • User’s Guide • Rev 01