12.Replace the outer blade washer (Fig. f).
13.Depress the spindle lock button (26) and replace the flat washer and blade bolt.
14.Use the 6mm hex key
to tighten the blade bolt securely (tighten in an anti- clockwise direction).
15.Lower the blade guard, hold the rotating lower blade guard (12) and blade bolt cover (14) in position and tighten the fixing screw (Fig. g).
16.Replace the guard retraction arm and secure onto the rotating blade guard (Fig. h).
17.Check that the blade guard operates correctly and covers the blade as the saw arm is lowered.
18.Connect the saw to the power supply and run the blade to make certain that it is operating correctly.
Cross-cutting (without slide action)
When cutting a narrow piece of wood it is not necessary to use the slide mechanism. In these cases ensure that the slide lock
(29)is screwed down to prevent the saw arm from sliding.
A crosscut is made by cutting across the grain of the workpiece. A 90º crosscut is made with the mitre table set at 0º (Fig. i). Mitre crosscuts are made with the table set at some angle other than zero.
f
g
h
i
1.Pull on the release knob (6) and lift the saw arm (5) to its full height.
2.Loosen the mitre lock (25).
3.Rotate the mitre table (21) until the pointer aligns with the desired angle.
4.Retighten the mitre lock (25).
WARNING. Be sure to tighten the mitre lock before making a cut. Failure to do so could result in the table moving during the cut and cause serious personal injury.
5.Place the workpiece flat on the table with one edge securely against the fence (18). If the board is warped, place the convex side against the fence (18). If the concave side is placed against the fence, the board could break and jam the blade.
6.When cutting long pieces of timber, support the opposite end of the timber with the side support bars (36), a roller stand or a work surface that is level with the saw table.
7.Use the clamp assembly (10) to secure the workpiece wherever possible.
8. It is possible to remove the | j |
clamp assembly (10) by |
|
loosening the clamp |
|
assembly lock (11) and |
|
moving it to the other side of |
|
the table. Make sure the clamp |
|
assembly lock is tight before |
|
using the clamp (Fig. j). |
|
9.Before turning on the saw, perform a dry run of the cutting operation to check that there are no problems.
10.Hold the operating handle (7) firmly and squeeze the switch trigger (24). Allow the blade to reach maximum speed.
11.Press the release latch (35) and slowly lower the blade into and through the workpiece.
15
