3. | Cut the grass by swinging the trimmer from right to |
| left and proceed slowly keeping the trimmer inclined |
| forwards at an angle of about 30°. Light cuts are better |
| than heavy cuts as they allow the cut grass to fall away |
| from the spool preventing the grass from clogging the |
| spool. |
4. | Start cutting nearest the mains power source and work |
| away from it to make it easier to avoid the extension |
| cord. |
5. | High grass should be cut in layers always beginning |
| from the top. Do not cut damp or wet grass. Do not |
| overload your trimmer. |
3.You can now use the line trimmer as an edger. The wheel is used to guide the line trimmer along the ground.
Trimming
Edgeing
6. | Avoid wearing the line out quickly by knocking against |
| hard objects (stones, walls, fences etc.). |
7. | Watch out for kickbacks in the event of impact with |
| hard objects. |
8. | After finishing the cutting operation, keep the head |
| close to ground level, release the switch and allow |
| the motor to come to a complete standstill. Place the |
| trimmer on the ground, switch off and remove the cable |
| plug from the mains supply. |
Note. Periodically clean out the grass between the spool and the rim of the guard to prevent the tool
from vibrating.
Using as an edger
Note. Always unplug the trimmer before carrying out any maintenance or making any adjustments to the line trimmer.
1. Press the handle rotating |
| |
1 | ||
button (14) and rotate | ||
| ||
the shaft 180 degrees, so |
| |
it is facing so the handle |
| |
is facing the opposite |
| |
direction. |
| |
2. Release the rotating |
| |
button (14), ensuring |
| |
that the handle clicks |
| |
into position. |
|
Changing a line spool
Warning. Ensure the cutting line blade cover is replaced.
Note. Always unplug the trimmer before carrying out any maintenance or making any adjustments to the line trimmer.
1. Turn the line trimmer upside |
| |
2 | ||
down. | ||
| ||
2. Hold the spool holder firmly |
| |
with one hand and with the |
| |
other hand squeeze the tabs |
| |
on either side of the spool |
| |
cover and remove the cover. |
| |
3. Remove the empty spool and |
| |
clean out the spool cover. |
| |
| ||
4. Align the cutaway sections in | 4 | |
the spool opposite the eyelets | ||
| ||
and thread the two lines of |
| |
the or new spool through |
| |
the two eyelets in the spool |
| |
holder and insert the spool. |
| |
|
|
10