Assembly
Fitting the guard and guide wheel
1.Align the 4 screw holes in the guard (8) with the screw holes in the base of the unit.
2.Place the edging wheel over the 2 screw holes at the front section of the guard.
3.Locate the 4 screws and washers and tighten them with a screwdriver.
Note. Always ensure the cutting line blade guard
(9)is fitted to the cutter blade whenever carrying out maintenance on the line trimmer.
Adjusting the telescopic handle
1.Push the telescopic shaft adjustment knob (13) and hold, adjust the shaft to a comfortable height. Make sure the button clicks into position once the desired height has been selected.
1
2
1
Fitting the secondary handle |
|
1. Hold in the secondary handle | 1 |
buttons and push the handle |
|
over them. |
|
2.To adjust the secondary handle press in the secondary handle buttons and rotate the handle to the desired position then release the buttons to lock it into place.
Extension cord support
There is a hole in the back of the handle of the line trimmer which is used as an extension cord retention device. To avoid detaching the extension cord always check that it is attached firmly during use.
1.Make a loop in the extension cord and push it through the square hole in the back of the handle.
1 |
| 2 |
|
|
|
2.Place the end of the loop around the securing hook (1) and pull back on the cord so it is firmly held in place.
Vertical handle adjustment |
| |
1 | ||
The handle can be adjusted | ||
| ||
so that it at horizontal with |
| |
the ground, this feature helps |
| |
you get access to areas such |
| |
as under bushes and garden |
| |
furniture. |
| |
The handle can be lowered by |
| |
pressing down on the handle |
|
8