adjustment pedal (15) on the base of the line trimmer with your foot. Then move the handle downwards to the desired angle.
Before starting
Before use, check that the tool is in good working order and that the length of the trimmer line is correct, as follows:
1.Ensure the switch is in the off position and disconnect the cable plug from the mains supply.
2.Examine the general condition of the tool. Inspect the guard, switch, cordset and extension cord. Check for loose screws, misalignment, binding of moving parts, improper mounting, broken parts and any other condition that may affect its safe operation. If abnormal noise or vibration occurs during operation, turn the line trimmer off immediately and have the problem corrected.
3.Ensure that you are on a flat surface and have secure footing.
4.Check that the line touches or goes beyond the edge of the guard.
Increasing the cutting line
1. Before starting ensure the |
| |
1 | ||
cutting line is the correct | ||
length. Pull the cutting |
| |
line to the edge of the |
| |
guard (8). |
|
2.If the line is to short push down on the automatic feed spool (10) and at the same time pull the line out so that it extends
a few centimeters past the edge of the guard.
3. Remove the cover from the | 3 |
line cutting blade (9). |
4.During operation to increase the cutting line simply switch the line trimmer off and then on again, this with restore the line to the correct length.
Note. Only remove the cover from the cutting line blade
when all operational checks have been carried out. Replace the cover when the line trimmer is not in use.
Switching on and off |
| |
2 | ||
1. Connect the extension cord | ||
| ||
to power. |
|
2.Press the
3.To switch off, release the trigger switch.
WARNING. The tool runs for
approximately 5 seconds after it has been switched off. Let the motor come to a complete standstill before setting the tool down.
Trimming
WARNING. Make sure that the work area is free of rocks, debris, lines and other foreign objects.
1.Start the trimmer before approaching the grass to be cut.
2.The automatic line feed mechanism releases 12mm from each line when the trimmer reaches a certain speed. If you need the spool to release more than 12mm of line per side, release the trigger until the speed falls beyond the trigger point then press the switch again. As the speed picks up a further 12mm will be released for both lines.
9
