Assembly
Inserting the shaft
Remove the nut from the hole in the base of the edger and insert the shaft. Replace the nut and retighten it.
Telescope handle adjustment The shaft handle can be set at three different heights.
To set the height for your comfort, slide the tube up to the level required using one of the three holes provided and insert the coach screw. Tighten the shaft height assembly adjustment knob (18).
Attaching the auxiliary handle To attach the auxiliary handle fit it onto the slot on the main handle.
Adjust it to the most comfortable position and insert the auxiliary handle locking knob (8), securing it firmly.
Fueling
MOTOR FUEL: MIX AT 40:1 ONLY
1.Use fresh unleaded petrol. You must use 100% synthetic oil specifically made for heavily stressed
2.Mix the petrol and oil in an approved container. Never mix fuel in the edger.
3.Place the edger upright on the ground or on
a sturdy bench and wipe any debris from around the fuel cap.
4.Unscrew the fuel tank cap and pour the mixture into the tank.
4a |
| 4b |
|
|
|
5.Be careful not to spill any mixture. If this happens, wipe the spill with a clean rag.
6.Start the engine at least three metres away from the area where the fuel tank has been filled up in order to avoid any risk of fire.
•Danger of fire and burn injury.
•Always use extreme care when handling fuel! Fuel is highly flammable.
•Never attempt to fuel the edger if the fuel system components are damaged or are leaking.
•Never attempt the refuel the engine while it is running or still warm, allow it to cool before fueling.
•Never smoke or light any fires near the edger or fuels.
•Always transport and store fuels in an approved container.
•Never place flammable material close the the engine muffler.
•Do not use petrol which contains ethanol or methanol as it may damage the fuel lines and other engine parts.
•Mix only enough fuel for your immediate needs. If fuel must be stored longer than 30 days, it should first be treated with a stabilizer or similar product.
8
