Starting the edger
Choke control
Start position (choke closed).
Run position (choke open).
To start the engine, proceed as follows:
1.Move the ignition switch (3) to the on position marked with an I.
2.Press the primer bulb (14) 6
times until there are no air2
bubbles visible in the fuel discharge line.
Note. This is not necessary if the engine is warm.
3. Push the choke lever (17) |
| |
up to the start position (the |
| |
| ||
choke is now closed). |
| |
3 | ||
Note. Again this is not necessary | ||
| ||
if the engine is warm. |
|
4.Pull the recoil starter (13)until the engine sounds like it wants to run.
5.Push the choke down to the run position.
6. Pull the recoil starter rapidly | 4 | |
until the engine starts. | ||
|
7.Allow the engine to run for 10 seconds to let it warm up.
8.To increase the engine speed depress the Lock Off button
(1) on the side of the handle and squeeze the throttle trigger(2).
Stopping the edger |
| |
4 | ||
Stop the engine by pressing the | ||
| ||
off button (3) to the off position |
| |
marked 0. |
|
Running in the engine
1.During the first ten hours of work, run the engine at a moderate RPM.
2.We advise you in any case not to maintain your engine at a high speed as the different components must settle with each other during the process of running in the engine.
3.It is at the end of the running in period that the engine will reach its maximum power.
4.After the first two hours of work, stop and make sure that all nuts and screws are securely fastened, and tighten them if necessary.
Cutting depth
The cutting depth of the edger can be altered to one of 3 settings 10mm, 20mm and 30mm.
1.To adjust the cutting depth, loosen the Height adjustment
knob approx | 2 |
but do not remove. |
|
2.Push the knob fully towards the body of the edger and at the same time move the front wheel arm across to the opposite side of the housing.
3.Raise or lower the arm to the
desired position, and then | 3 | |
pull the height adjusting knob | ||
|
9
