CLEANING
10.After cleaning and drying the knife cover place it back into position on the slicer.
11.Push the chute release knob inward and turn it clockwise until it is securely tightened.
NOTE: The slicer will not operate unless the knife cover is in place and the knife cover release knob is securely tightened.
12.Soak a clean cloth in a mild detergent and warm water solution. Ring out excess water from cloth. With the slicer table completely closed, wipe theslicer table off by starting at the knife and pulling towards you. Never wipe the slicer table towards the knife.
13.Dilute cleaner per instructions on the label. Products containing sodium hypochlorite should not be used on the slicer. Clean and wipe down the entire slicer including the food chute and end weight. Use a mild
DO NOT use caustic or strong detergents on the slicer base or components.
REASSEMBLY
1. Tilt the food chute back into position (Fig.
2. Manual slicers are equipped with a cleaning brace that raises the slicer to allow cleaning underneath. Push the food chute to the back of the slicer. Lift up the front of the slicer and pull the brace completely towards the front of the slicer and lower the unit (Fig.
Figure
3.After cleaning the counter area under the slicer, lower slicer back to its operating position.
Figure
Page 13