GN Netcom SE-220 installation instructions Troubleshooting

Models: SE-220

1 28
Download 28 pages 10.86 Kb
Page 22
Image 22

TROUBLESHOOTING

Troubleshooting will help you overcome difficulties that occur during installation and normal use.

No Dial Tone

Check the connections of the telephone lines to the LIM, and make sure that the connections are secure at both the wall jack, and on the LIM. Repeat the process for the telephone connection from the LIM to the console, and make sure both ends of the console cable are securely plugged in.

Be sure the power cable is connected to the console, and the power adapter is plugged securely into a working wall outlet or power strip.

If you are not receiving dial tone on a headset, but you can hear dial tone on the handset and speaker, make sure the 2.5mm connector is plugged securely into the headset jack on the console.

Try a different phone line.

In Speaker Mode: Short Silences, Echoes, or Clipped Speech

At the beginning of a call, allow someone at each location to speak in turn for few moments to enable SoundPoint Pro to adapt to its environment.

Avoid moving the SoundPoint Pro console when in use.

Do not cover or block the microphone(s) with hands, papers, cups, etc., during use.

Difficulty with Hearing the Other Party

Noisy equipment such as a copy machine may make it difficult for you to hear the other party. Both parties should turn off any noisy equipment while talking.

Try calling again to see if another line provides a better connection.

Check that the power adapter is plugged into a working outlet and the power plus is securely plugged into the console.

You Can’t Hear

Use the key to adjust the volume for handset, headset, or speaker.

YourCaller Can’t HearYou

If using the handset, check the handset cord connections.

Be sure that the phone is not on Mute, as indicated by the lit LED on the Mute Key.

If using a headset, check the connection to the console and make sure that the microphone is properly positioned in front of your mouth.

SoundPoint Pro Desktop Conference Phone Troubleshooting

3–2

Blank Display

Check that the power adapter is plugged into a working outlet, and the power plug is securely plugged into the console.

Physical Damage

If physical damage is severe enough that the internal parts become visible, disconnect SoundPoint Pro immediately. Do not reconnect it to the telephone network until SoundPoint Pro is repaired.

If you need more help, call your Polycom reseller, or call Polycom Technical Support at: 1-800-POLYCOM.

SoundPoint Pro Desktop Conference Phone Troubleshooting

3–3

Page 22
Image 22
GN Netcom SE-220 installation instructions Troubleshooting