6.Press two 57.1mm Round Outer Caps (59) onto the ends of the Front Leg (1).
Pull the Seat Knob (36) out as far as it will go and remove the Seat Frame (19) from the Bench Frame (2) and set it aside.
Orient the Bench Frame (2) as shown. Slide the Front Bench Frame Plate (39) into the indicated end of the Bench Frame, and align the holes in the Plate with the holes in the Bench Frame.
Orient the Front Leg (1) as shown. Attach the Front Leg to the Bench Frame (2) with the Front Bench Frame Plate (39), four M8 x 25mm Button Screws (74) and four M8 Split Washers (104).
7.Orient the Seat (20) and Seat Backing (115) as shown. Attach the Seat and Seat Backing to the Seat Frame (19) with four M6 x 16mm Screws (67).
8.Pull the Seat Knob (36, not shown) out as far as it will go, and slide the Seat Frame (19) onto the Bench Frame (2). Engage the Seat Knob into the third hole from the end of the Bench Frame.
Press the two Frame Inner Caps (58), with the wide ends oriented as shown, into the ends of the Bench Frame (2). Attach the Caps with four M4 x 16mm Screws (86).
Locate the Short Nylon Rope (54), which has three ends connected in the middle with a bracket. Note that two ends of the Rope go out of one side of the bracket, and the third (single) end goes out the other side of the bracket. Route the single end of the Short Nylon Rope under a
8
6 |
|
| 36 |
|
|
|
|
| |
| 39 |
| 2 | 19 |
|
| Holes | ||
59 | 104 |
| 104 |
|
| 74 |
| 74 |
|
| 1 | 59 | ||
|
| |||
7 |
|
|
| 20 |
|
|
|
| |
Round |
|
| 115 | |
| End |
|
| |
|
|
|
| 19 |
8 | 67 |
|
|
|
|
| Third |
|
|
| |
| 36 | Hole |
|
|
|
|
|
|
|
| |
86 | 2 |
|
|
|
|
|
|
|
|
| |
58 | 86 | 19 |
|
| Wide |
Wide |
|
| |||
1 | 49 | 86 | 2 | End | |
End |
| ||||
72 | 54 |
|
|
| 58 |
| 88 |
|
| 86 | |
|
|
|
|
