11.Lower the Uprights (70, 76) as shown.
Start the two indicated Console Screws (67) into the Left and Right Uprights (70, 76) and the con- sole assembly. If necessary, pull back on the console assembly slightly to align the holes in the Uprights with those on the console assem- bly. Start the other two Console Screws (67) before tightening all four Console Screws; do not overtighten the Console Screws.
12.See the inset drawing. Push the Uprights (70, 76) sideways so that the treadmill Frame (26) is centered between the Uprights.
Firmly tighten the Upright Bolts (84, 85) on each side of the treadmill.
With the help of a second person, carefully raise the Uprights (70, 76) to a vertical position.
11 | Console | Start First |
| Assembly | 67 |
|
|
Start |
| 70 |
First | 67 |
|
|
| |
| 76 |
|
12 | Side View |
|
| 70, 76 | 85 |
|
| |
| 26 | 84 |
|
| |
| View From Above |
|
70 | 26 | 76 |
13.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 22 and 23).
10
