If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1. | Make sure that the power cord is unplugged. | 91 |
|
|
| Remove the indicated #8 x 1/2" Screw (1) and | Small |
| |
| the Access Door (87) from the Console Back |
| Small | |
| (91). |
| Screws | |
2. Connect the wire on the receiver to the indicated |
| Receiver | Cylinder | |
| wire extending from the Console Back (91). |
|
|
|
| Hold the receiver so the small cylinder is ori- |
|
| 87 |
| ented as shown and is facing the Console |
|
| |
| Back. Attach the receiver to the plastic posts on |
|
|
|
| the Access Door (87) with the two included |
| Wire | 1 |
| small screws. |
| ||
3. Be careful not to pinch the wires. Reattach |
|
|
| |
| the Access Door (87) with the #8 x 1/2" Screw |
|
|
|
| Screw (1). Discard the other wires included with |
|
|
|
| the receiver. |
|
|
|
11
