3.3 REFRIGERATING CYCLE
3.3.1CONDENSER, EVAPORATOR AND CAPILLARY TUBE(HEAT EXCHANGE ASSEMBLY)
1.Remove the insulation on the H/E assembly
2.Pierce the
3.After discharging the refrigerant completely, remove 2 screws between the shroud and H/E. (See Figure 17)
4.Lift the H/E and open the H/E around 45 degree clockwise carefully.
5.Unbrace two interconnecting tubes of the evaporator and condenser carefully.
6.Remove the H/E assembly from the shroud. (See Figure 18)
7.Unbrace the capillary tube at the connections of each condenser and evaporator. (See Figure 19)
8.Remove 4 screws between condenser and evaporator. (See Figure 19)
— 13—
Figure 17
Figure 18
Figure 19