Gossen 15122 Functioning of the Digisix, Preparation and self-test Battery, Self-Test

1 The functioning of the Digisix

1.1Preparation and self-test

Battery

The Digisix is powered by a 3 V Lithium battery, type CR 2032.

When the battery is running low, the signal BAT appears in the display.

–The battery should be replaced as soon as possible. When BAT is shown alone in the display, the battery will need to be replaced before further measurements are possible.

–To replace the battery, pull out the battery compartment placed under the eyelet for the carrying cord.

–Remove the old battery and insert the new one. Observe the "+" and "–" polarity!

–Close the battery compartment Attention! Changing the battery will cancel all the individual values stored in memory.

Self-Test

After the new battery has been inserted, the microcomputer will carry out a self-test. Every display segment appears in the display panel.

The self-test takes 10 seconds. It can be interrupted before by pressing any button.

After the self-test, the standard settings will be shown as set by the factory.

Standard settings

ISO 100/21° COR 0 EV 8

GOSSEN Foto- und Lichtmeßtechnik 4