Gossen 15122 operating instructions Function Timer

The EV in the display will blink to remind you that the standard factory calibration has been changed. Input of the correction in 1/3-stops in the range of ± 3 EV.

For cancelling the correction value, remove the battery from the compartment for a moment and then put it back again.

In case of over-exposure a positive correction, in case of under-exposure

a negative correction value should be set.

2.5Function TIMER

A timer function is provided in the Digisix, useful for long exposure or other timings ranging from one second to thirty minutes.

–Use the function button to select the function TIMER and hold it down until the OK-signal sounds. The display shows the last value used. The read-out will show the "minutes" and will flash to allow the countdown timer to be adjusted.

–Use the key M to enter the desired time in minutes.

–Confirm by pushing the function button. The read-out "seconds" in the display will flash.

GOSSEN Foto- und Lichtmeßtechnik 10