GoVideo DDV 9300 manual Basic Tuner Settings, Setting Antenna & Channel Memory, Channel Selection

1

2

3

4

You can change channels with the Channel Up/Down buttons or directly with the number keys.

Setting Antenna & Channel Memory

Your Dual-Deck VCR will automatically tune in all available TV Stations whether from Antenna reception or Cable (CATV). Simply indicate the Antenna Source and then run Auto Program:

1 Press MENU until the DUAL-DECK FEATURES menu appears.

2 Press “1” to select VCR SETTINGS/SET CLOCK.

3 Press “2” to select TUNER/CHANNEL LIST.

4 Press repeatedly to set the ANTENNA SOURCE to Antenna or Cable.

5 Press or to move the selection arrow to AUTO PROGRAM.

6 Press to begin Auto Program. The VCR will cycle through all possible TV or cable channels and automati- cally place the channels you receive into Channel Memory. This will take a few minutes to complete.

7 Press QUIT to exit the menu system or MENU to return to the VCR SETTINGS menu.

If you are using a cable converter box, you will need to set your VCR’s tuner channel to receive only the cable converter box output channel (see p.39).

Your channel list must have a minimum of 2 channels; one channel is not valid.

Basic Tuner Settings

Channel Selection

• Tuning with the Channel Up/Down Buttons

Press the CHANNEL Up/Down buttons on the remote control or on the Dual-Deck VCR’s front panel to move up or down to the desired channel.

• Tuning with the Number Buttons

For channels 1 through 9, press “0” then press the correspond- ing number button (1-9). If you are tuning to a channel higher than 100, press 100+ and then enter the last two digits.

• Selecting Line 1 or Line 2

You can select Line 1 or Line 2 with the CHANNEL Up/Down buttons. Line inputs are located after the highest pro- grammed station and before the lowest programmed station. When you select Line 1 or Line 2, you will see the input (if any) from additional video equipment connected to your Front or Rear Audio/Video inputs.

CHAPTER 3 - INITIAL SETTINGS 17