GoVideo DVR1000 manual Troubleshooting, Symptom Cause Correction

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Symptom	Cause	Correction
No power.	The power cord is disconnected.	Plug the power cord securely into the
		wall outlet.	REFERENCE
The power is on, but	No disc is inserted.	DVD+VCR appears on the TV screen.
		Insert a disc or tape. (Check that the
the DVD+VCR does not	No tape is inserted.	disc or tape indicator is lit on the front
work.		panel display.)
No picture.	The TV is not set to receive DVD+VCR	Select the appropriate video input on
	signal output.	the TV so the picture from the
	TV/VCR mode for DVD+VCR is set to	Press the TV/VCR button on the remote
	TV.	control repeatedly to choose VCR
		mode. The TV indicator will disappear
		on the front panel display.
	The video cable is not connected	Connect the video cable securely.
	securely.
	The connected TV power is turned off.	Turn on the TV.
No sound.	The equipment connected with the	Select the correct input on the audio
	audio cable is not set to receive	receiver so you can listen to the sound
	DVD+VCR signal output.	from the DVD+VCR.
	The audio cables are not connected	Connect the audio cables securely.
	securely.
	The power of the equipment connected	Turn on the equipment connected with
	with the audio cables is turned off.	the audio cables.
	The Digital Audio Output is set to the	Set the Digital Audio Output to the
	wrong position.	correct position, then turn on the
		DVD+VCR again by pressing POWER.
The playback picture is	The disc is dirty.	Clean the disc.
poor.
	Tape heads are dirty.	Clean video heads.
	Tape is a rental or was recorded on	Use TRK (+/-) for manual tracking
	another VCR.	adjustment while tape is playing.
The DVD+VCR does	No disc is inserted.	Insert a disc or tape. (Check that the
	No tape is inserted.	disc or tape indicator is lit on the front
not start playback.
		panel display.)
	An unplayable disc is inserted.	Insert a playable disc. (Check the disc
		type, color system, and Regional code.)
	The disc is placed upside down.	Place the disc with the playback side down.
	The disc is not placed within the guide.	Place the disc on the disc tray correctly
		inside the guide.
	The disc is dirty.	Clean the disc.
	The Rating level is set.	Cancel the Rating function or change
		the rating level.
The remote control	The remote control is not pointed at the	Point the remote control at the remote
does not work properly.	remote sensor on the DVD+VCR.	sensor on the DVD+VCR.
	The remote control is too far from the	Operate the remote control within 23 ft
	DVD+VCR.	(7 m).
	There is an obstacle in the path of the	Remove the obstacle.
	remote control and the DVD+VCR.
	The batteries in the remote control are	Replace the batteries with new ones.
	dead.
	This remote control uses the same	When using the VCR deck, first press
	buttons for VCR and DVD functions	the VCR button. When using the DVD
	(ex. PLAY).	deck, first press the DVD button.

33