Component Description
Compressor Requirements
NOTE: This sprayer requires an external air compres- sor.
CAUTION
Install an air filter on external air compressor to reduce contamination to spray system.
Air compressor range: 10 scfm to 35 scfm, 30 to 140 psi
Material | Air Requirements* | Minimum |
|
| Compressor |
|
| Size* |
|
|
|
Elastomerics | 30 scfm at 90 psi | 15 HP |
(textured) | (0.84 m3/min at |
|
| 0.63 MPa, 6.3 bar) |
|
|
|
|
Simulated | 20 scfm at 60 psi | 5.5 HP |
Accoustical | (0.56 m3/min at |
|
| 0.42 MPa, 4.2 bar) |
|
|
|
|
Splatter Coat | 15 scfm at 40 psi | 8 HP |
and | (0.42 m3/min at |
|
Knockdown | 0.28 MPa, 2.8 bar) |
|
|
|
|
Orange Peel | 20 scfm at 60 psi | 8 HP |
| (0.56 m3/min at |
|
| 0.42 MPa, 4.2 bar) |
|
|
|
|
*Material, temperature and volume affect cfm needed to properly atomize material.
Maintenance
CAUTION
DFor detailed engine maintenance and specifica- tions, refer to separate HONDA engine manual.
DClose black fuel shutoff lever whenever you are transporting sprayer to prevent fuel from flooding engine.
DKeep sprayer upright and level when operating it and when transporting it. This prevents crankcase oil from leaking into combustion chamber, which makes startup very difficult.
Daily: Check engine oil level and fill as needed.
Daily: Check and fill gas tank.
Daily: Check sprayer air filter, clean and replace element as needed.
6 309662
After first 20 hours of operation and each 100 hours thereafter: Change oil.
Weekly: Remove engine air filter cover and clean element. In very dusty environments, check filter daily. Replace element as needed. Replacement elements can be purchased from your local HONDA dealer.
Spark plug: Use only a (NGK) BP6ES or BPR6ES plug. Gap plug to 0.025 to 0.030 in. (0.7 to 0.8 mm). Always use a spark plug wrench.
6 months: Clean Air Flow Sensor as follows:
1.Fig. 3. Loosen adapter (A). Pull down quick re- lease (C) and swing out flow sensor regulator. Disconnect connector (B).
2.Remove inlet fitting (D), retainer ring (E), piston (F) and spring (G) from flow sensor regulator (H).
CAUTION
Do not scratch or nick piston (F) or inside of flow sensor regulator (H).
3.Clean all parts (D, E, F, G). Clean inside of (H) with a pipe cleaner.
4.Assemble all parts and install flow sensor regula- tor.
Flow | C |
Sensor Regulator |
|
B
A
D E | F G | H | |
|
|
| Flow |
Fig. 3 |
|
| Sensor Regulator ti4366a |
