
Setup
Spraying Stains or Clear Coats (Fine-Finish Optimizer)
The
Installation
1. Remove material cup and suction tube.
2.Push
2.Put prime/relief valve to UP position, then hold trig- ger in for 10 seconds.
ti14999a
3. Put prime/relief valve DOWN to spray position.
4.Reverse spray tip to UNCLOG position and trigger sprayer into a waste area.
5.Engage trigger lock and put prime/relief valve UP to release pressure.
Cleanup/Storage
Be sure to remove and clean the
ti14994a | ti14999a |
6.Unscrew and remove material cup.
7.Disengage trigger lock, put prime/relief valve DOWN, hold sprayer slightly above material cup, and pull trigger to discharge fluid from pump.
Sprayer Setup
This sprayer arrives from the factory with a small amount of test material in the system. It is important that you flush this material from the sprayer before using it for the first time:
1. Fill material cup with water and thread onto sprayer.
ti14992a
ti15478a
8. Discard material in cup.
3A0153E | 9 |