Graco 2L01VIB, 2L02VIB Battery Installation, Using AC Adapters, Selecting Channels, Parent Unit

Battery Installation

Parent Unit

•Remove the battery door cover on the Parent Unit with a key or flat blade screw

driver.

• Place 3-AAA (1.5V-LR03) batteries into	+	-
	-
the battery compartment. Note the		+
proper orientation of the batteries.	+	-

•Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon zinc), or rechargeable (ni-cadmium, etc) batteries.

• Place the battery door back on the unit.	Batteries should be disposed of
• Please remove a dead battery promptly.
	properly by recycling.
A dead battery left in the unit may leak,
damaging your unit.

•Do not attempt to recharge a non-rechargeable battery.

•A rechargeable battery CANNOT be recharged by plugging the AC adapter into the Parent Unit.

•Remove the batteries from the unit if it is no longer being used or will be stored for an extended period of time.

Using AC Adapters

•The Parent Unit uses 3-AAA (1.5V-LR03) batteries or standard 120 volt AC household current. The Nursery Unit uses standard 120 volt AC household current.

•To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the Parent Unit and the back of the Nursery Unit. Then plug adapter into a standard wall outlet.

•Use ONLY the Graco adapters included with the unit. Do not use these adapters with other equipment under any circumstances.

•If units do not work, check that AC adapters are plugged into working outlets.

Selecting Channels

•In case you are experiencing some interference, the channel on the Nursery Unit can be changed by sliding the “ch” button on the side of the unit to either channel A or B ("X" or "Y").

•The channel on the Parent Unit can be changed by sliding the “ch” button on the side of the unit to either channel A or B ("X" or "Y").

NOTE: Both units must be on the same channel.

A

B

A

B

3